Transverse Strength Machine
1.0 Product Information:
1.1 General Information
Transverse Strength Machine is equipped with a loading mechanism and sensing mechanism which are controlled by PLC and observed on screen touch HMI. It can measure transverse strength of ¼”X1”X4” Specimen of resin coated sand.
1.2 General Usage
Keep the specimen on two point support & press of start button, within few seconds the equipment shows the reading.
1.3 Product Data
Product Name:
Product Code:
VTAD I
Order Reference Code:
V0000115
Electrical Supply Required:
230v 50Hz A.C. (Default)
110v 60 Hz A.C (Optional)
Single Phase, Stabilized with Over/ Under Voltage cut-off.
Electrical Plug:
M type : 15 Amp Plug
Typical Maximum Current:
1.5 A at 230V
Compressed air Supply:
Not Required
Communication:
Ethernet (RJ45)
Cloud Sync using V-Sync
Dimensions:
490 X 330 X 435 mm (WXBXH)
Packing Dimensions:
610 mmx 490mm x 690 mm (WXBXH) Typical
Net Weight:
Approximately 43 kg
Gross Weight:
Approximately 53 kg
Colour:
Factory Default
Measuring Range:
Strength: 145 Kg/cm2
Traceable to:
NABL Standards
Least Count:
Transverse: 0.1 Kg/cm2
Specimen Requirements:
Required
Operating Temperature:
0-500C
Testing Standards:
AFS
Calibration Frequency:
22500 nos. of Testing Cycles or Once in Year
2.0 Scope of Supply
2.1 Inclusions in Supply Scope
Transverse Strength Machine.
Calibration plate.
Calibration certificate.
Instruction manual.
2.2 Exclusions in Supply Scope
Data interfacing accessories.
Anything that is not covered under Supply scope.
3.0 Recommended Pre-requisite Equipment
Sand Splitter : To get representative sample
Specimen preparation equipment’s to make a standard specimen.
4.0 Accessories
4.1 Calibration Kits
Standard dead weights.
4.2 Attachments
NA
5.0 Alternative Equipment
Transverse Strength Machine VTAD
6.0 Installations Instructions
Required Levelled (2mm) and sturdy platform. (Equipment should be away from external source of vibration or electromagnetic interference.) Other Installation instruction shall be provided along with the equipment.
7.0 Consumables
8.0 Hazards
Squeezing Hazard: Do not insert hand or limb in between the two point support & single point support, when in operation.
9.0 Additional Information
Link to Web-Page
Link to Video of Demo
Disclaimer: Specifications and design of equipment may change without prior notice.
