1.0 Product Information:
1.1 General Information
This is a precision equipment to measure Permeability of Foundry Sands. By default it can measure absolute permeability of an AFS (Dia. 2”X2”) or Metric (Dia. 50mmX50mm) Specimen.
With Help of attachment it can also measure
Relative Permeability of Moulds (Refer 4.2.1)
Absolute Permeability of Cores (Refer 4.2.2)
Absolute Permeability of Un-bonded sand (Refer 4.2.3).
1.2 General Usage
Specimen held in a Tube or accessory is placed on the measuring Rubber Boss. Start the test cycle & get the Permeability reading.
1.3 Product Data
Product Name:
Digital Permeability Meter
Product Code:
VPD
Order Reference Code:
V9000792
Electrical Supply Required:
230v 50Hz A.C. (Default)
110v 60 Hz A.C (Optional)
Single Phase, Stabilized with Over/ Under Voltage cut-off.
Electrical Plug:
M type : 15 Amp Plug
Typical Maximum Current:
2.2 A at 230V
Compressed air Supply:
Not Required
Communication:
RS485 MODBUS RTU
RS232 Serial
Ethernet (Optional)
CloudSync using V-Sync
Dimensions:
500 X 320 X 460 mm (WXBXH)
Packing Dimensions:
600 mmx 450mm x 625 mm (WXBXH) Typical
Net Weight:
Approximately 25 kg
Gross Weight:
Approximately 30 kg
Colour:
Factory Default
Measuring Range:
0-100 mmWC and Related readings AFS Permeability measurement chart digitally displayed.
Traceable to:
Manufacturers Standards
Least Count:
1 mmWC
Specimen Requirements:
Compression type specimen
Operating Temperature:
0-500C
Testing Standards:
BIS: Standard
AFS: Optional
Calibration Frequency:
22500 nos. of Testing Cycles or Once in Year
2.0 Scope of Supply
2.1 Inclusions in Supply Scope
Digital Permeability Meter.
Large Orifice.
Syphon Pump.
Calibration certificate.
Instruction manual.
2.2 Exclusions in Supply Scope
Precision small orifice. (Part # V4500256)
Data interfacing accessories.
Anything that is not covered under Supply scope.
3.0 Recommended Pre-requisite Equipment
Sand Splitter : To get representative sample
Specimen preparation equipment to make a standard AFS or Metric Compression specimen.
4.0 Accessories
4.1 Calibration Kits
There are four types of calibration kits to choose from:
VKPA: With Std. Specimen type for Small Orifice
VKPB: With Std. Specimen type for Large Orifice
VKPC: With Rubber Boss type for Small Orifice
VKPD: With Rubber Boss type for Large Orifice
4.2 Attachments
VPR: Mould Perm Tester
VD: Core Permeability Tube
VBP: Base Permeability Tube
Small Orifice
5.0 Alternative Equipment
Permeability Meter VP (For Educational Purposes)
Electropermeability Meter VEP
VCAT Multi Tester
6.0 Installations Instructions
Required Levelled (2mm) and sturdy platform. (Equipment should be away from external source of vibration or electromagnetic interference.) Other Installation instruction shall be provided along with the equipment.
7.0 Consumables
Demineralized Water
Rubber Boss Assembly (Part # V4500259)
8.0 Hazards
No Major Hazards.
9.0 Additional Information
Link to Web-Page
Link to Video of Demo
Disclaimer: Specifications and design of equipment may change without prior notice.
