1.1 General Information
Hot Distortion Tester is equipped with a gas burner mechanism, specimen clamping mechanism and sensing mechanism which are controlled by PLC and observed on screen touch HMI. By default it can measure distortion of a 1/4”x1”x4”) standard transverse specimen.
1.2 General Usage
Take the standard transverse specimen (1/4”X1”X4”). Lift sensor probe up side by figure & slide the specimen in specimen clamping area and clamp it. Release the sensor probe on specimen. Press the start key, equipment shows displacement against time span.
1.3 Product Data
Product Name:
Hot Distortion Tester
Product Code:
VHD I
Order Reference Code:
V0000116
Electrical Supply Required:
230v 50Hz A.C. (Default)
110v 60 Hz A.C (Optional)
Single Phase, Stabilized with Over/ Under Voltage cut-off.
Electrical Plug:
M type : 15 Amp Plug
Typical Maximum Current:
1.2 A at 230V
Compressed air Supply:
Not Required
Communication:
Ethernet (RJ45)
CloudSync using V-Sync
Dimensions:
685x390x360 mm (WxBxH)
Packing Dimensions:
790x500x460 mm (WXBXH) Typical
Net Weight:
Approximately 40 kg
Gross Weight:
Approximately 50 kg
Colour:
Factory Default
Measuring Range:
Distortion: ±7mm
Traceable to:
NABL Standards
Least Count:
Distortion: 0.01 mm
Specimen Requirements:
Required
Operating Temperature:
0-500C
Testing Standards:
BIS/AFS
Calibration Frequency:
22500 nos. of Testing Cycles or Once in Year
2.0 Scope of Supply
2.1 Inclusions in Supply Scope
Hot Distortion Tester.
Standard calibration plate.
Calibration certificate.
Instruction manual.
2.2 Exclusions in Supply Scope
Data interfacing accessories.
Anything that is not covered under Supply scope.
3.0 Recommended Pre-requisite Equipment
Sand Splitter : To get representative sample
Specimen preparation equipment’s to make a standard specimen.
4.0 Accessories
4.1 Calibration Kits
Standard slip gauge: 7mm
4.2 Attachments
N.A.
5.0 Alternative Equipment
Hot Distortion Tester VHD
6.0 Installations Instructions
Required Levelled (2mm) and sturdy platform. (Equipment should be away from external source of vibration or electromagnetic interference.) Other Installation instruction shall be provided along with the equipment.
7.0 Consumables
LPG
8.0 Hazards
Burning Hazard: Don’t touch to probes, burner & heated or broken specimen.
9.0 Additional Information
Link to Web-Page
Link to Video of Demo
Disclaimer: Specifications and design of equipment may change without prior notice.
