1.0 Product Information:
1.1 General Information
Wet Tensile Tester is equipped with a loading mechanism, heating mechanism and sensing mechanism which are controlled by Microcontroller or PLC and observed on LCD display.
1.2 General Usage
Specimen held in a tube with special tube cap is placed on the specimen tube seat. On press of start button, after curing time the equipment shows wet tensile reading.
1.3 Product Data
Product Name:
Wet Tensile Tester
Product Code:
VWT
Order Reference Code:
V0000037
Electrical Supply Required:
230v 50Hz A.C. (Default)
110v 60 Hz A.C (Optional)
Single Phase, Stabilized with Over/ Under Voltage cut-off.
Electrical Plug:
M type : 15 Amp Plug
Typical Maximum Current:
6.9 A at 230V
Compressed air Supply:
5 Kg/cm2 Dry Air
Communication:
RS485 MODBUS RTU
RS232 Serial
Ethernet (Optional)
CloudSync using V-Sync
Dimensions:
350 X 460 X 535 mm (WXBXH)
Packing Dimensions:
450 mmx 560mm x 685 mm (WXBXH) Typical
Net Weight:
Approximately 53 kg
Gross Weight:
Approximately 63 kg
Colour:
Factory Default
Measuring Range:
60 Gm/cm2
Traceable to:
NABL Standards
Least Count:
0.05 Gm/cm2
Specimen Requirements:
Required
Operating Temperature:
0-500C
Testing Standards:
BIS: Standard
AFS: Optional
Calibration Frequency:
22500 nos. of Testing Cycles or Once in Year
2.0 Scope of Supply
2.1 Inclusions in Supply Scope
Wet Tensile Tester.
Special tube, Special tube cap & Special pedestal cup
Calibration dead weights set
Hand gloves set asbestos
Calibration certificate.
Instruction manual.
2.2 Exclusions in Supply Scope
Data interfacing accessories.
Anything that is not covered under Supply scope.
3.0 Recommended Pre-requisite Equipment
Sand Splitter : To get representative sample
Specimen preparation equipment’s to make a standard AFS or Metric specimen.
4.0 Accessories
4.1 Calibration Kits
VKHC: For Temperature
Calibration dead weights
4.2 Attachments
NA
5.0 Alternative Equipment
6.0 Installations Instructions
Required Levelled (2mm) and sturdy platform. (Equipment should be away from external source of vibration or electromagnetic interference.) Other Installation instruction shall be provided along with the equipment.
7.0 Consumables
8.0 Hazards
Burning Hazard: Heater temperature 230oC. Don’t touch to heaters.
9.0 Additional Information
Link to Web-Page
Disclaimer: Specifications and design of equipment may change without prior notice.
