1.1 General Information
This handheld equipment consists of a Dial indicator with Special tip designed for measurement of mould strength directly on mould.
1.2 General Usage
Tip of the equipment is pressed against mould surface to observed mould strength in kg/cm2.
1.3 Product Data
Product Name:
Mould Strength Tester
Product Code:
VMS
Order Reference Code:
V0000085
Electrical Supply Required:
Not Required
Electrical Plug:
Not Applicable
Typical Maximum Current:
Compressed air Supply:
Communication:
Dimensions:
190x120x40mm (WXBXH)
Packing Dimensions:
230x230x130 mm (WXBXH) Typical
Net Weight:
Approximately 0.750 kg
Gross Weight:
Approximately 1.1 kg
Colour:
Factory Default
Measuring Range:
0-2 Kg/cm2
Traceable to:
NABL Standards
Least Count:
0.05 Kg/cm2
Specimen Requirements:
Operating Temperature:
0-500C
Testing Standards:
BIS: Standard
AFS: Not Applicable
Calibration Frequency:
22500 nos. of Testing Cycles or Once in Year
2.0 Scope of Supply
2.1 Inclusions in Supply Scope
Hand-held equipment.
Head Pipe Cap.
A box to house the equipment when not in use.
Calibration certificate.
Instruction manual.
2.2 Exclusions in Supply Scope
Anything that is not covered under Supply scope.
3.0 Recommended Pre-requisite Equipment
NA
4.0 Accessories
4.1 Calibration Kits
VKMC: Calibration Kit for Mould & Core Hardness tester
4.2 Attachments
5.0 Alternative Equipment
VCAT Mark II
6.0 Installations Instructions
7.0 Consumables
8.0 Hazards
No Major Hazards.
9.0 Additional Information
Link to Web-Page
Disclaimer: Specifications and design of equipment may change without prior notice.
