1.0 Product Information:
1.1 General Information
Hot Shell Tensile Tester is equipped with a loading mechanism, heating mechanism and sensing mechanism which are controlled by Microcontroller or PLC and observed on LCD display. By default it can measure the hot tensile strength.
With Help of attachment it can also measure
Cold Tensile Strength (Refer 4.2.1)
1.2 General Usage
Hot shell tensile tester has been designed as a complete unit for forming, curing and breaking the specimen in the same position. Fill the sand sample in jaws cavity, press the START key & after curing time equipment shows the hot tensile strength reading.
1.3 Product Data
Product Name:
Hot Shell Tensile Tester M
Product Code:
VHTD
Order Reference Code:
V0000042
Electrical Supply Required:
230v 50Hz A.C. (Default)
110v 60 Hz A.C (Optional)
Single Phase, Stabilized with Over/ Under Voltage cut-off.
Electrical Plug:
M type : 15 Amp Plug
Typical Maximum Current:
10.6 A at 230V
Compressed air Supply:
Not Required
Communication:
RS485 MODBUS RTU
RS232 Serial
Ethernet (Optional)
CloudSync using V-Sync
Dimensions:
615 X 385 X 475 mm (WXBXH)
Packing Dimensions:
715 mmx 485mm x 625 mm (WXBXH) Typical
Net Weight:
Approximately 46 kg
Gross Weight:
Approximately 56 kg
Colour:
Factory Default
Measuring Range:
50 Kg/cm2
Traceable to:
NABL Standards
Least Count:
0.05 Kg/cm2
Specimen Requirements:
Operating Temperature:
0-500C
Testing Standards:
BIS: Standard
AFS: Optional
Calibration Frequency:
14500 nos. of Testing Cycles or Once in Year
2.0 Scope of Supply
2.1 Inclusions in Supply Scope
Hot Shell Tensile Tester.
Jaw set.
Tray, Sand sampler & Lifting Tong.
Calibration certificate.
Instruction manual.
2.2 Exclusions in Supply Scope
Data interfacing accessories.
Anything that is not covered under Supply scope.
3.0 Recommended Pre-requisite Equipment
Sand Splitter : To get representative sample
Hot Air Blower Mixer VHA
4.0 Accessories
4.1 Calibration Kits
VKHA: For Dead Weight Hanging
VKHB: Dead Weights
VKHC: For Temperature
4.2 Attachments
VHC: Cold Shell Tensile Strength Attachment
5.0 Alternative Equipment
NA
6.0 Installations Instructions
Required Levelled (2mm) and sturdy platform. (Equipment should be away from external source of vibration or electromagnetic interference.) Other Installation instruction shall be provided along with the equipment.
7.0 Consumables
8.0 Hazards
Burning Hazard: Heater temperature 230oC. Don’t touch to heaters.
9.0 Additional Information
Link to Web-Page
Disclaimer: Specifications and design of equipment may change without prior notice.
