1.1 General Information
Stick point tester is equipped with a heating mechanism and sensing mechanism which are controlled by Microcontroller and observed on LED 7 segment display.
1.2 General Usage
The stick point tester is used to determine the stick point of thermosetting mixture of the sand and synthetic resin or resin coated silica sand.
1.3 Product Data
Product Name:
Stick Point Tester
Product Code:
VMP
Order Reference Code:
V0000041
Electrical Supply Required:
230v 50Hz A.C. (Default)
110v 60 Hz A.C (Optional)
Single Phase, Stabilized with Over/ Under Voltage cut-off.
Electrical Plug:
M type : 6 Amp Plug
Typical Maximum Current:
1.6 A at 230V
Compressed air Supply:
Not Required
Communication:
Not Applicable
Dimensions:
490x125x240mm (WXBXH)
Packing Dimensions:
690x400x400mm (WXBXH) Typical
Net Weight:
Approximately 10 kg
Gross Weight:
Approximately 16 kg
Colour:
Factory Default
Measuring Range:
0-1500C
Traceable to:
Manufacturers Standards
Least Count:
10C
Specimen Requirements:
Operating Temperature:
0-500C
Testing Standards:
BIS: Standard
AFS: Not Applicable
Calibration Frequency:
4600 nos. of Testing Cycles or Once in Year
2.0 Scope of Supply
2.1 Inclusions in Supply Scope
Stick Point Tester.
Temperature controller.
Leaf type sensor.
Calibration certificate.
Instruction manual.
2.2 Exclusions in Supply Scope
Anything that is not covered under Supply scope.
3.0 Recommended Pre-requisite Equipment
Hot Air Blower Mixer VHA
4.0 Accessories
4.1 Calibration Kits
VKHC: For Temperature
4.2 Attachments
NA
5.0 Alternative Equipment
6.0 Installations Instructions
Required Levelled (2mm) and sturdy platform. (Equipment should be away from external source of vibration or electromagnetic interference.) Other Installation instruction shall be provided along with the equipment.
7.0 Consumables
8.0 Hazards
Burning Hazard: Heater temperature 230oC. Don’t touch to heaters.
9.0 Additional Information
Link to Web-Page
Disclaimer: Specifications and design of equipment may change without prior notice.
