1.1 General Information
Transverse Strength Attachment is suitable to connect to Universal strength machine model VUD/VUN (Digital/Hydraulic). It can measure the strength of an AFS 1”X1” or Metric 7/8”X7/8” cross-section area transverse specimen.
1.2 General Usage
Keep the specimen in between two point support & single point support, start the test cycle & get the transverse strength reading on base equipment.
1.3 Product Data
Product Name:
Transverse Strength Attachment
Product Code:
VTS
Order Reference Code:
V0000035
Electrical Supply Required:
Required for base equipment
Electrical Plug:
Not Applicable
Typical Maximum Current:
Compressed air Supply:
Not Required
Communication:
Dimensions:
200x50x90mm (WXBXH)
Packing Dimensions:
230x230x130mm (WXBXH) Typical
Net Weight:
Approximately 0.5 kg
Gross Weight:
Approximately 1 kg
Colour:
Factory Default
Measuring Range:
500 Kg/cm2 (Model VUN)
600 Kg/cm2 (Model VUD)
Traceable to:
Manufacturers Standards
Least Count:
10 Kg/cm2 (Model VUN)
1 Kg/cm2 (Model VUD)
Specimen Requirements:
Transverse type
Operating Temperature:
0-500C
Testing Standards:
BIS: Standard
AFS: Optional
Calibration Frequency:
15500 nos. of Testing Cycles or Once in Year
2.0 Scope of Supply
2.1 Inclusions in Supply Scope
Transverse Strength Attachment.
(Pair of specimen support)
Instruction manual.
2.2 Exclusions in Supply Scope
Anything that is not covered under Supply scope.
3.0 Recommended Pre-requisite Equipment
Universal Strength Machine Digital VUD
Or
Universal Strength Machine Hydraulic VUN
Specimen preparation equipment’s to make a standard AFS or Metric specimen.
4.0 Accessories
4.1 Calibration Kits
NA
4.2 Attachments
5.0 Alternative Equipment
6.0 Installations Instructions
Required Levelled (2mm) and sturdy platform for base equipment. Other Installation instruction shall be provided along with the equipment.
7.0 Consumables
8.0 Hazards
Squeezing Hazard: Do not insert hand or limb in between the pads when in operation.
9.0 Additional Information
Link to Web-Page
Disclaimer: Specifications and design of equipment may change without prior notice.
